Hands down, Foam-Tac is the best choice for building and repairing all parts of foam planes including motor mounts, control horns and rods, attaching servos, and tacking down wires.

Foam-Tac’s improved formula now contains UV blockers so that it can be used in the field in direct sunlight without any yellowing or degrading. We’ve also added a special adhesion promoter to make the glue even stronger and more durable than before.

FOAM-TAC offers many advantages over other types of glues that have been used on R/C planes. Since a little Foam-Tac goes a long way, you’ll build plane after plane with one bottle, saving time, money and materials.

Directions for Use

All surfaces must be clean, dry, and free of dust and grease.

Remove white cap & save for storage.

Apply a thin layer of glue to each side of materials to be joined.

Wait a few seconds and then firmly press parts together and immediately separate for 4-5 seconds more.

Rejoin parts, firmly pressing surfaces together for a permanent bond.

Allow to dry for 15-20 minutes.

Full cure within 2-14 hours.